Deep Penetrating Primer Tiefgrund 3L

<p>Water-soluble, ready-to-use, deeply penetrating primer for porous mineral surfaces before painting, wallpapering, tiling, or plastering.</p><u>Properties:</u><ul><li>For interior and exterior use</li><li>Deeply penetrates the substrate</li><li>Suitable for strengthening weak surfaces (lime, chalk, etc.)</li><li>Equalizes the surface absorption capacity</li><li>Provides excellent adhesion for subsequent coatings</li><li>Use before painting, wallpapering, tiling, or plastering</li><li>Reduces paint consumption</li><li>Almost odourless</li><li>Maximum VOC content in product &lt;30 g/l</li><li>Colour - milky white, transparent after drying</li><li>Consumption 6 - 10 m²/l depending on surface porosity</li><li>Package volume 3 l</li></ul><u>Suitable surfaces:</u><ul><li>Mineral surfaces</li><li>Lime</li><li>Chalk</li><li>Plaster</li><li>Fillers</li><li>Concrete</li><li>Aerated concrete</li><li>Stone</li><li>Cement</li><li>Brick</li><li>Plasterboard</li><li>Fibreboard</li><li>Chipboard</li></ul><u>Application:</u><p>The surface to be treated must be dry and free from dust, grease, and other contaminants. Previously painted surfaces should be cleaned of old peeling paint, roughened, and rinsed with water. Surfaces covered with mould or moss must be mechanically cleaned and treated with Biotol E or Biotol Spray, rinsed with water, and allowed to dry. Filled and plastered surfaces must be fully dry before treatment.</p><p>Mix the product before use. The substrate and air temperature during application must not be lower than +5°C or higher than +30°C. Apply to the surface with a brush, spray, or roller. Highly absorbent surfaces should be treated using the "wet on wet" method until saturation. When treating dense surfaces, the primer may be diluted with water by up to 25%. After drying, the primer must not form a glossy film on the surface. The effectiveness of priming depends on the type of chalk, lime, etc. being primed, the layer thickness, and how absorbent the base surface is. The primed surface must be completely dry before further treatment. Minimum drying time is 12 hours.</p><p>Application tools - brush, roller, sprayer. Clean tools with soap and water.</p><p>Drying - at least 12 hours at 20°C and 65% relative humidity. At lower temperatures and higher humidity, drying time increases. Wait until the surface is completely dry before further treatment.</p>

11.69 € EUR 9.79 € EUR (-16%)

SKU: 209701

Brand: Eskaro

EAN: 4740381012716

This product is available at Zum.lv - the largest online store in Latvia.

View product on site