Contact Primer 0.7l

<p>Mineral filler-based primer for interior and exterior use. Used to create an adhesive layer on dense, glossy surfaces. Suitable for monolithic concrete walls, ceilings, floors, reinforced concrete structures, surfaces covered with plasterboard, and more. Surfaces treated with Contact Grund can be plastered (with gypsum, gypsum-lime, lime-cement plasters, etc.), filled, and painted with structural paints. The product can be used for renovation work in older buildings where oil and alkyd paints have been used on walls.</p><u>Properties:</u><ul><li>Excellent adhesion to dense and glossy surfaces</li><li>Creates a rough surface to which plaster and adhesive mixtures, structural coatings adhere well</li><li>The dried surface is moisture-resistant</li><li>Maintains the vapor permeability of the surface</li><li>Almost odorless</li><li>Maximum VOC content in the ready-to-use product &lt; 30 g/l</li><li>Color - light pink</li><li>Consumption ~350 g/m² depending on the substrate and tool</li><li>Volume 0.7 l</li></ul><u>Suitable surfaces:</u><ul><li>Concrete</li><li>Monolithic concrete</li><li>Reinforced concrete</li><li>Plasterboard</li><li>Painted surfaces, etc.</li></ul><u>Application:</u><p>The surface to be treated must be dry, free from dust, grease, and other contaminants. Heavily soiled or greasy surfaces should be washed with a 3–5% soda solution, rinsed with clean water, and allowed to dry. Surfaces covered with mold or moss must be mechanically cleaned and treated with Biotol E or Biotol Spray, rinsed with water, and allowed to dry. The temperature of the surface to be treated must be above +5°C. Do not treat frozen surfaces.</p><p>Before use, stir the primer and if necessary dilute with water (up to 5% by volume). Apply to the surface with a brush or roller at temperatures above +5°C. Ensure that the temperature does not drop below +5°C during drying. Plasters and other structural coatings should be applied to the primed surface after the primer has fully dried. Do not allow dust to accumulate on the primed surface before further processing.</p><p>Application tools - brush, roller. Wash tools with soap and water.</p><p>Drying time 12–24 hours at 20°C and 65% relative humidity. At lower temperatures and higher humidity, drying time increases. Wait for the surface to dry completely before further processing.</p>

5.49 € EUR 4.59 € EUR (-16%)

SKU: 209700

Brand: Eskaro

EAN: 4740381020711

This product is available at Zum.lv - the largest online store in Latvia.

View product on site