Deep Primer Tiefgrund 10L

<p>Water-soluble, ready-to-use deeply penetrating primer for porous mineral surfaces before painting, wallpapering, tiling, and plastering.</p><u>Properties:</u><ul><li>For interior and exterior use</li><li>Deeply penetrates the substrate</li><li>Suitable for strengthening weak surfaces (lime, chalk, etc.)</li><li>Equalizes surface absorbency</li><li>Provides excellent adhesion for subsequent coatings</li><li>Use before painting, wallpapering, tiling, and plastering</li><li>Reduces paint consumption</li><li>Almost odorless</li><li>Maximum VOC content in product &lt;30 g/l</li><li>Color - milky white, transparent after drying</li><li>Consumption 6 - 10 m²/l depending on surface porosity</li><li>Package volume 10 l</li></ul><u>Suitable surfaces:</u><ul><li>Mineral surfaces</li><li>Lime</li><li>Chalk</li><li>Plaster</li><li>Fillers</li><li>Concrete</li><li>Aerated concrete</li><li>Stone</li><li>Cement</li><li>Brick</li><li>Plasterboard</li><li>Fibreboard</li><li>Chipboard</li></ul><u>Application:</u><p>The surface to be treated must be dry, free from dust, grease, etc. and other contaminants. Previously painted surfaces should be cleaned of old peeling paint, roughened and rinsed with water. Surfaces covered with mold or moss must be mechanically cleaned and treated with Biotol E or Biotol Spray, rinsed with water and allowed to dry. Filled and plastered surfaces must be completely dry before treatment.</p><p>Mix the product before use. The temperature of the substrate and air during application must not be lower than +5°C or higher than +30°C. Apply to the surface with a brush, spray, or roller. Highly absorbent surfaces should be treated using the "wet on wet" method until saturation. When treating dense surfaces, the primer can be diluted with water up to 25%. After drying, the primer must not form a shiny film on the surface. The effectiveness of priming depends on the type of chalk, lime, etc. being primed, the layer thickness, and how absorbent the base of the surface being primed is. The primed surface must be completely dry before further treatment. Minimum drying time 12 hours.</p><p>Application tools - brush, roller, sprayer. Wash tools with soap and water.</p><p>Drying - at least 12 hours at 20°C and 65% relative humidity. At lower temperatures and higher humidity, drying time increases. Wait for the surface to dry completely before further treatment.</p>

29.59 € EUR 24.69 € EUR (-17%)

SKU: 209684

Brand: Eskaro

EAN: 4740381012723

This product is available at Zum.lv - the largest online store in Latvia.

View product on site