Self-leveling compound mira 6700 cemplan 25 kg 1-45mm

<p>Self-leveling compound for the finishing layer. 6700 cemplan is recommended for creating a smooth and even layer on concrete and screed. It is a thin-layer leveler for wet and dry rooms. 6700 cemplan can be applied with hand tools or a mechanical pump.</p><u>Properties:</u><ul><li>Fast setting</li><li>Cement base</li><li>Polymer reinforced</li><li>Good adhesion</li><li>Wear resistant</li><li>Pumpable</li><li>For leveling cement-based substrates</li><li>Average consumption 1.7 kg/m²/mm</li><li>Layer thickness 1 - 45 mm</li><li>Application temperature +10 to +20°C</li><li>Working time 15 - 20 min</li><li>Hardening for light load 2 h</li><li>Further processing after 6 - 12 h</li><li>Waterproofing application after 12 - 18 h</li><li>Compressive strength 25 N/mm²</li><li>Flexural strength 5 N/mm²</li></ul><u>Application:</u><p>6700 cemplan can be used on concrete surfaces, screed and lightweight concrete. On concrete screeds the layer thickness is 1 – 45 mm, on lightweight concrete the recommended layer thickness is 5 – 30 mm.</p><p>The substrate must be firm, dry, hard, and clean of dust, dirt, grease, etc. Any crumbling parts of the concrete substrate must be removed, and loose and dusty parts are best collected with a vacuum cleaner. Dirt and grease must be cleaned with 7110 base cleaner or a high-pressure water device, or another cleaning method.</p><p>Absorbent substrates should be primed with a solution in the ratio of 1 part 4180 primer to 3 parts water. On non-absorbent surfaces, apply 4140 primer in concentrated form. Wooden surfaces should be primed with concentrated 4180 primer. Before applying each subsequent layer, the surface must be primed. Apply the primer to the surface with a brush.</p><p>25 kg of powder should be mixed with approx. 4.75 – 5.25 l of clean water. Mix for 2 minutes with a slow-rotating mixer or pump mixer until a homogeneous mass is obtained. The mixed mass must be processed within approximately 15 – 20 min at room temperature from +10 to +20 °C. The applied mass flows out on its own, but it can also be smoothed afterwards and leveled in corners with a smoothing spatula. For light load, light foot traffic, the surface is ready after approx. 2 h. Drying depends on the air temperature and humidity in the room. Further coating and processing of the surface can be carried out after 6 h. Surface tiling can be done after 12 – 18 h. In bathrooms and wet rooms, the surface must be coated with the mira 4400 multicoat system.</p>
15.79 € EUR
SKU: 206071
Brand: mira
EAN: 5701914670017

This product is available at Zum.lv - the largest online store in Latvia.

View product on site