Tile Adhesive mira 3100 unifix (C2T) Grey 25 kg
<p>Tile adhesive with improved adhesion. Suitable for bonding ceramic tiles in interior and exterior applications, in dry and wet areas. Since tile adhesive 3100 unifix is based on grey cement, it is not recommended for bonding thin translucent tiles or glass mosaic, as there is a risk that the adhesive may show through.</p><u>Properties:</u><ul><li>Cement base</li><li>Good adhesion</li><li>Moisture resistant</li><li>Grey</li><li>Non-slump</li><li>Easy to use</li><li>Frost resistant</li><li>Average consumption for walls 2 kg/m², for floors 3.4 kg/m²</li><li>Working time 6 h</li><li>Hardening for further processing after 10 - 24 h</li><li>Fully hardened after 7 days</li></ul><u>Application:</u><p>Intended for stable floors and walls with minimal deformation and surface tension, plastered brick and block walls, gypsum board panels, concrete elements, surfaces with minimal shrinkage, movement and deformation.</p><p>The substrate must be firm, dry, hard, and clean of dust, dirt, grease, etc. The substrate is primed with 4180 primer; in wet areas in accordance with applicable regulations, ETAG 022 and mira installation recommendations.</p><p>25 kg of powder should be mixed with 6.25 – 7 L of clean water and stirred until a homogeneous lump-free mass is obtained. It is recommended to use an adhesive mixer for mixing. It is advisable to observe the minimum and maximum working temperatures for the dry mix, water and substrate. After mixing, the adhesive must be used within 6 h. It is not recommended to apply adhesive to larger surfaces than can be tiled before the skin effect appears. The 3100 adhesive should be applied to the substrate with the smooth side of the trowel and spread well over the surface, then combed with the notched side of the trowel. The notch size depends on the tile size and the substrate. Press the tiles into the wet adhesive with a slight movement. Continuously check that the back of the tiles is fully covered. In areas larger than 36 m² and in spans larger than 8 m, it is advisable to incorporate expansion joints in accordance with good construction practice. Joint filling can be carried out after a period of time depending on the absorption of the tiles and substrate and the air temperature (for walls approx. 10 h, for floors approx. 18 h).</p>
10.59 €
EUR
SKU: 206077
Brand: mira
EAN: 5701914505302
- Tile adhesive mira 3130 superfix extra flexible, white 5 kg
- Tile Adhesive FKE Flexible 25kg Grey
- Tile Adhesive Knauf K2 25kg Flexible
- Tile Adhesive Knauf K4 25kg Extra Flexible
- Knauf Perlfix 12kg Plasterboard Adhesive
- Knauf Perlfix 30kg Plasterboard Adhesive
- Tile Adhesive FK 25kg Grey
- Tile Adhesive Tilecol 24A 310ml Ready-to-Use
- Tile Adhesive FFK Extra Flexible 25kg
- Tile Adhesive FFK Extra Flexible 5kg
- Tile Adhesive FFKs Extra Flexible 5kg Fast Setting
- Tile Adhesive FKE 12.5kg Grey
This product is available at Zum.lv - the largest online store in Latvia.
View product on site