Tile Adhesive Mira Unifix 3110 25kg Flexible White
<p>White, non-slip tile adhesive with good adhesion and improved flexibility. Suitable for heated floors, natural stone, glass mosaic, ceramics, etc. Suitable for bonding ceramic, clinker and natural stone tiles with water absorption greater than 0.5%, for interior and exterior use, in dry and wet areas.</p><u>Properties:</u><ul><li>Flexibility (S1)</li><li>White cement base</li><li>Polymer reinforced</li><li>Very good adhesion</li><li>Water resistant</li><li>Non-slip – tiles will not slide</li><li>Suitable for natural stone and glass mosaic</li><li>Long adjustment time</li><li>Frost resistant</li><li>Average consumption for walls 2 kg/m², for floors 3.5 kg/m²</li><li>Application temperature +10 to +25°C</li><li>Working time 6 h</li><li>Hardening for further processing after 10 - 14 h</li><li>Fully hardened after 7 days</li></ul><u>Application:</u><p>Intended for stable floors and walls with minimal deformation and surface tension, plastered brick and block walls, plasterboard panels, concrete elements, surfaces with minimal shrinkage, movement and deformation. The substrate must be firm, dry, hard, and free from dust, dirt, grease, etc. The substrate is primed with 4180 primer; in wet areas in accordance with applicable regulations, ETAG 022 and mira installation recommendations.</p><p>25 kg of powder should be mixed with 6.25 – 7 l of clean water and stirred until a homogeneous lump-free mass is obtained. It is recommended to use an adhesive mixer for mixing. It is recommended to observe the minimum and maximum working temperatures for the dry mix, water and substrate. After mixing, the adhesive must be used within 6 h. It is not recommended to apply adhesive over larger areas than can be tiled before the skinning effect occurs. The 3110 Unifix adhesive should be applied to the substrate with the smooth side of the trowel and spread well over the surface, then combed with the notched side of the trowel. The notch size depends on the tile size and the substrate. Press the tiles into the wet adhesive with a slight movement. Continuously check that the back of the tiles is fully covered. In areas larger than 36 m² and in spans larger than 8 m, it is advisable to incorporate expansion joints in accordance with correct construction requirements. Joints can be grouted after a period of time depending on the absorption of the tiles and substrate and the air temperature (approximately 10 hours for walls, approximately 18 h for floors).</p>
16.59 € EUR
13.59 € EUR
(-18%)
SKU: 206069
Brand: mira
EAN: 5701914311064
- Tile Adhesive Mira Unifix 3110 5kg Elastic White
- Tile Adhesive mira 3100 unifix (C2T) Grey 25 kg
- Tile adhesive mira 3130 superfix extra flexible, white 5 kg
- Tile Adhesive FKE Flexible 25kg Grey
- Tile Adhesive Knauf K2 25kg Flexible
- Tile Adhesive Knauf K4 25kg Extra Flexible
- Knauf Perlfix 12kg Plasterboard Adhesive
- Knauf Perlfix 30kg Plasterboard Adhesive
- Tile Adhesive FK 25kg Grey
- Tile Adhesive Tilecol 24A 310ml Ready-to-Use
- Tile Adhesive FFK Extra Flexible 25kg
- Tile Adhesive FFK Extra Flexible 5kg
This product is available at Zum.lv - the largest online store in Latvia.
View product on site